SCM Automatic Wide Belt Sander Cs-95 R001001

FEATURES:

SINGLE COMBINED UNIT “CS” equipped with:
– ‘CR/120’ roller, 120 mm diameter
– 85 SH rubber coated roller
– manual adjustment of working height
– ‘TRP/I’ flat stiff pad made of an extractable bar with felt contact insert density D=”0,68
– manual adjustment of working height
– glued graphite cloth
“CRA” Helicoidal grooved steel calibrating roller
“TSP/I” Semi-stiff flat pad
– for the sanding of veneered panels The pad is made of an extractable bar with rubber contact insert + felt density
D=”0,68
On/Off pneumatic selector of the roller
– activated by pneumatic cylinder, complete with micrometric adjustment of roller position according to the abrasive
belt thickness
On/off pneumatic selector for the pad
– activated by pneumatic cylinder, complete with micrometric adjustment of lining on pressure shoes position according
to the abrasive belt thickness
2 infeed support rollers and two outfeed support rollers
Electronic positioning for working table
– It is equipped with decimal adjustment to pre-set higher or lower workpiece positioning.
– The worktable fall and rise is activated by a sensor and a microswitch located near the gauge.
– On/off selectors allow to disactivate this device in order to carry out the thickness set up by means of fall/rise
worktable pushbuttons

TECHNICAL DATA:
– Working width [mm] : 950
– Min./max. working thickness [mm] : 4-170
– Sanding belt width [mm] : 970
– Sanding belt length [mm] : 1525
– Main motor power [kW (HP)] : 5,5 (7,5)
– Feed belt motor power [kW (HP)] : 0,3/0,55 (0,4/0,7)
– Feed belt speed [m/min] : 4,5/9